Repels mold and mildew: Removal, disassembly, penetration, and bleaching
Triple power of oxygen x penetration x foam to remove mold 2-part mixture type bathtub cleaner Penetrates deep into stubborn mold roots for quick and easy cleaning. Can also be used to clean bath accessories
Disinfecting 99.99% (*Not all bacteria are kilized. According to our company's research/countermeasure bacteria from the source of circulating bathtubs
Usable Baths: Can be used with hot water / Eco cute (heat pump water heater type) / 24-hour baths / jet baths / artificial stone baths *Eco cute (heat pump water heater) / 24-hour baths / jet baths may vary depending on the model. Please check the instruction manual or manufacturer before using
Cannot be used for bathrooms and bathrooms: Type with no reheating function, natural stones such as marble baths, wooden baths, painted items, aluminum, copper products
Formulated with antibacterial ingredients, anti-reattachment agent, soap scum remover
This bathtub powder cleaning agent is made of 100% natural ingredients with 5 types of aids including potassium fatty acid (pure soap ingredient), and carbonates as the main ingredient
Made in Japan. Contents: 10.6 oz (300 g) (1 bag) x 3 bags. Liquid: Alkaline
Estimated usage amount: 1 bag (10.6 oz (300 g) per 7.1 gal (200 L) to 300 liter tubs, Caution: 24 hours baths (type of circulation purification using activated carbon, purification stone, etc.), cypress bathtubs, foreign bathtubs, and marble. Please do not soak anything other than plastic products
How to Use: [1. Put this product in the remaining water] Put the remaining hot water or water up to 3.9 inches (10 cm) above the hole, and put this product (100 - 300 liter tub, 10.6 oz (300 g) in the bathtub. For two holes, please fill the amount of water or hot water at least 3.9 inches (10 cm) from the top hole. 2. Stir well and dissolved: Stir well, boil hot water in a well-melted area. The temperature is approximately 104°F (40°C). When it comes with a jet bath function, it is even more effective when it is activated. If the water temperature is low, the cleaning effect cannot be performed. Be sure to use a scratcher rod or wear rubber gloves. [3. Soak Overnight] After stopping the boiling water, please leave it for 12-14 hours. At this time, you can put the bath chair or washbasin in in the tub to remove stains together. 4. Lightly rub: Before draining, chase it again (about 5 minutes) and then drain the water and rinse thoroughly in the bathtub until it is no more nulu feeling in the shower. If you lightly rub the equipment soaked with a sponge, the dirt will be removed. [Exceptions: For cleaning bath around the bathtub] Dissolve 2-3 tablespoons (20-30g) of hot or water in 3.5 fl oz (100 ml) of water, apply the liquid to a sponge, and wash walls, tiles, grout and shower curtains. Then rinse thoroughly
Powerful Oxygen Power to Remove Dirt Firmly : A bath cleaner formulated with oxygen-based bleach and more. Powerful oxygen power removes water spots and invisible stains. 99.9% sterilization, deodorizing Not all bacteria disinfects and deodorizes. For a single hole of a floor, this set contains 4 5.6 oz (160 g) serving
[How to use] Use 5.6 oz (160 g) (total volume) in the bathtub (standard: about 300 L). It is recommended that you use it regularly every 1-2 months. Please do not remove the filter in the bathtub. 1. Fill with water or leftover water with this product (full amount) and stir. Please do not use leftover water containing bath liquids. Please check that there is water or leftover water up to about 2.0 inches (5 cm) above the hole. 2. Drive after 2-3 minutes and leave it for about 10 minutes. In the following situation, please follow it for about 10 minutes. When using for the first time, when cold water is heavily dirty, or if it has been over 2 months after previous use, 3. Drainage and add water to about 2 inches (5 cm) above the tub hole. 4. For rinsing, chase for about 5 minutes and drain the water when finished
(Can't be used): Baths with no function to follow or chase them, but bathtubs made of wood, polycarbonate products, painted items, marble, copper, and aluminum products that cannot be fixed at a certain temperature of the hot water. *Jet bath, 24-hour bath, and heat pump water heater may vary depending on how you use it, so please refer to the instruction manual or contact the bathtub manufacturer
Precautions for Use: Do not use for anything other than its intended purpose. Do not take a bath while washing. Please use gloves for cooking if you have rough conditions. Avoid direct sunlight, and do not place in places with high temperatures or humidity. Please do not place this product in a location that is exposed to children and pets. Please store out of the reach of infants and people with dementia to prevent them from accidentally swallowing this product. Do not mix with chlorine or reduced bleach. In order to avoid sucking in powder, please keep it away from your face when opening or dispensing. Please use scissors to open the product and use the entire amount. Please do not attach to clothing. Colors may bleed. Wash your hands thoroughly after use. Please do not use hot water. (First Aid) In the event that it gets in your eyes, do not rub, rinse it off with running water for 15 minutes, and consult an ophthalmologist. If accidentally swallowed, rinse your mouth immediately and consult a physician. If it gets on your skin, rinse it thoroughly with water, and consult a physician. In any case, please bring the product to you at checkout
Product Details: Capacity (1 piece): 5.6 oz (160 g) / Flusher Cleaning Agent / Uses: Cleaning Bathtub / Liquidity: Weak alkaline / Ingredients: Bleach (percarbonate) / Alkaline agent (carbonate), Reposition prevention agent, Surfactant (polyoxyethylene propylene glycol), Made in Japan